Understanding LED indicator status lights and information

Find out what the LED indicator light on your product tells you about the status of your product.

Videobar VB-S Status Indicators

Appearance	Activity	System State
	Status indicator is off. A small section of lights in the center of the light bar is bright white.	Camera is off. VB‑S is powered on. No active meeting.
	Status indicator is on. A small section of lights in the center of the light bar is dim white.	Camera is on. No active meeting.
	Status indicator is off. The whole light bar is lit solid white.	Camera is off. Meeting is active.
	Status indicator is on. The whole light bar is lit solid white.	Camera is on. Auto-framing is disabled. Meeting is active.
	A small section of lights in the center of the light bar is lit solid white. Status indicator is on.	Camera is on. Auto-framing is enabled. Meeting is active.
	The leftmost light on the light bar blinks once. The status indicator maybe on or off.	A decrease volume level command has been received.
	A small section of lights on the left end of the light bar blinks once. The status indicator maybe on or off.	The lowest volume level has been reached
	The rightmost light on the light bar blinks once. The status indicator maybe on or off.	An increase volume level command has been received.
	A small section of lights on the right end of the light bar blinks once. The status indicator maybe on or off.	The highest volume level has been reached
	All lights in the light bar are lit solid red. The status indicator maybe on or off.	The VB‑S microphone is muted.
	A small section of lights in the center of the light bar pulses white once and then fades off. Status indicator is off.	The VB‑S has connected to a Wi‑Fi network or has detected a new audio source connected to its USB port. No active meeting.
	A small section of lights in the center of the light bar is blinking white rapidly.	The VB‑S is searching for a Wi‑Fi network.
	Two small sections of lights in the light bar are solid red. The rest of the light bar is solid amber.	The VB‑S is not functioning properly. This may be due to a connection issue or a firmware issue. Make sure the VB‑S is connected to a network. Refer to either the Videobar Configuration app or Videobar Administration app to do this. If the network configuration is correct but the issue is not resolved. the videobar may need service.
	White lights in the light bar move repeatedly from right to left and then from left to right.	The VB‑S is downloading and installing a firmware update. Do not disconnect the VB‑S from its power outlet or network. When the update is complete, the light bar will stop moving, and the VB‑S will play an audio tone.
	A small section of lights in the center of the light bar pulses white repeatedly. The lights then move outward from the center until the whole light bar is lit solid white. The lights then fade out.	The VB‑S is restarting after restoring its factory default settings.
	A small section of lights in the center of the light bar pulses purple repeatedly.	The VB-S has received an "Identify Device" message from the Videobar Administration app.